>PURPLE PROSE

>STEP 1:
Begin by unpacking section A (fig 1 i). Unfold flap H first, as shown. Gently prise sub-flap K4 up, thus releasing tetrafold E9. Remove contents.

STEP 2:
Start the assembly by laying flat prime struts 1 and 2 (fig 5 iii), making sure to present open planes in isometric alignment (fig 5 iv).

STEP 3:
Insert johnnyscrews (leaving aside inert johnnyscrews for section 14a) halfway into assigned holes in substrate prime struts (now having been rotated proximally 45 degrees), taking care to leave post-rounded ends exposed.

STEP 4:
Prepare supporting braces 23a and 23b by aligning pre-trasversal skewlines (fig 43 xi) and attaching adjacent pulse sockets A-K.

STEP 5:
When socket A is turned counterclockwise, pin appendage J17 can be attached using 1/4 inch crowscrew (fig 13 ii). Repeat procedure for all remaining sockets, save those with preturned asquegient bearing.

STEP 6:
Once sequential arc-tumblers have been supinely positioned against now assembled prime struts, reverse angle quadrature can now be easily achieved (fig 356 xiv). The pretractilate supporting braces will now slide into postcoiled Gram’s grooves 3 and 4.

STEP 7:
Enjoy!

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s